System > Ipv6 System Settings; System > Ipv6 Route Settings - D-Link DGS-1210-28 Reference Manual

4 Configuration
Login Timeout: The Login Timeout controls the idle time-out period for security purposes, and when there is
no action for a specific time span in the Web-based Management. If the current session times out (expires),
the user is required a re-login before using the Web-based Management again. Selective range is from 3 to
30 minutes, and the default setting is 5 minutes.
System > IPv6 System Settings
The IPv6 System Settings page allow user to configure the IPv6 system information.
IPv6 System Settings:
Interface Name: Displays the interface name of IPv6.
IPv6 State: Specifies the IPv6 to be enabled or disabled.
DHCPv6 Client: Specifies the DHCPv6 client to be enabled or disabled.
IPv6 Network Address: Specifies the IPv6 Network Address.
NS Retransmit Time Settings:
NS Retransmit Time (1-3600): Specifies the NS retransmit time for IPv6. The field range is 1-3600, and
default is 1 second.
Automatic Link Local State Settings:
Automatic Link Local Address: Specifies the automatic link is enabled or disabled.
Click Apply for the settings to take effect.
System > IPv6 Route Settings
The IPv6 Route Settings page allows user to configure the IPv6 route settings.
IP Interface: Specify the IP interface which to be created.
Default Gateway: The corresponding IPv6 address for the next hop Gateway address in IPv6 format..
Metric: Represents the metric value of the IP interface entered into the table. This field may read a number
between 1 and 65535.
Figure 4.19 – System > IPv6 System Settings
Figure 4.20 – System > IPv6 Route Settings
2 1
2 1
D-Link Web Smart Switch User Manual