Connect To The Camera Using Static Ip - Lengrad CM7100 User Manual

Connect to the Camera using Static IP

If no DHCP server is in the network or the camera does not get IP from DHCP server, user can connect
the camera to a computer directly, using static IP to configure the camera.
The default IP, if no DHCP server; or DHCP offer time out (3 minutes), is 192.168.1.168
1. Connect the computer RJ-45 via an Ethernet cable directly to the IP camera CM7100.
2. Configure the computer using Static IP: 192.168.1.XXX (1<XXX<255, but NOT 168) and configure
the "Subnet mask" to "255.255.255.0". Leave the "Default Gateway" to "Blank" like below:
3. Power on the CM7100.
4. Start the IE or Firefox browser when the network connection is up.
5. Enter 192.168.1.168 in the address bar of the browser.
6. The browser will ask for plug-in or ActiveX if not installed, otherwise it will get to Home page and
start to show the video captured by the camera (by default the camera enabled anonymous access)
7. Click the "Configuration" icon (middle one at lower left, looks like tools) and the browser will ask
credentials to authorize configuration.
8. Enter the administrator user name and password to access the Web Configuration Interface, the
default user name and password are both set to admin.
9
Page
301 Fulling Mill Road, Suite G
Middletown, PA 17057
(800)-321-2343
©Copyright 2014 by Legrand
All Rights Reserved.
www.legrand.us