Networking Settings Page - Lengrad CM7100 User Manual

Networking Settings Page


IP Address Configuration:
o
Dynamically Associated via DHCP: Default setting, DHCP server assigns IP to camera.
o
Statically Configured as:

DNS Configuration:

HTTP:
NOTE:
 If the camera is behind a SOHO router with port forwarding configured for remote
access, static IP has to be used to avoid IP address changes after a router reboot.
 TCP ports above 5000 are suggested if port forwarding HTTP remote access, as some
ISPs block port 80 inbound traffic. For example, change the default HTTP port from 80 to
8088, to make sure the port forwarding is not likely to be blocked.

In addition to the HTTP port, an RTSP port may also required for port forwarding, in
order for remote party viewing the H.264 video.
 If changing the default port from TCP 80 to port "A", then the RTSP port should be
"2000+A". Both TCP port "A" and "2000+A" should be configured for port forwarding in
the router. For example, the HTTP port changed to 8088, the RTSP port should be
10088, both 8088 and 10088 should be configured for port forwarding in order for remote
camera video access.
Figure 5: Networking Settings Page
Enter Static IP address manually
Obtained automatically or entered manually.
Web access TCP port, default 80.
14
Page
301 Fulling Mill Road, Suite G
Middletown, PA 17057
(800)-321-2343
©Copyright 2014 by Legrand
All Rights Reserved.
www.legrand.us