Lengrad CM7100 User Manual page 12


On Screen Display (OSD):
o OSD Text screen:
o OSD Position:
o Display Time:
o Display Text:

Primary Stream Settings:
o Preferred Video Codec: MJPEG and H.264 supported, H.264 recommended.
o Profile:
o Resolution:
o Bit Rate:
o Maximum Frame Rate:
o Bit Rate Control:
o Image Quality:
o I-frame Interval:

Secondary Stream Settings:

Audio Settings:
o Preferred Audio Codec: PCMU, PCMA, AAC supported.
o Microphone Volume:
o Speaker Volume:
o
Light Condition:
NOTE:
 H.264 is the high resolution Codec, while MJPEG is the Codec used automatically for
remote smartphone viewing.
 If MJPEG selected, reduce max. frame rate to min. value to save bandwidth and get
better image
Displays time stamp and text on the video screen.
Input text (to identify the camera) shown on the screen.
Show the OSD in either top or bottom position on screen.
When checked, time stamp will display on video screen
When checked, input text will display on video screen.
H.264 profile selection. Default is "Main Profile."
The video resolution in pixels used in video of camera
Video bit rate used
Maximum frame rate used.
Constant bit rate, or variable bit rate
Image quality used when Variable Bit Rate used
I-frame interval
Same as primary steam.
Slide to adjust microphone gain.
Slide to adjust the speaker volume.
Select correct local power frequency to avoid video
flicking effect under fluorescence light condition. Default is
Outdoor.
12
Page
301 Fulling Mill Road, Suite G
Middletown, PA 17057
(800)-321-2343
©Copyright 2014 by Legrand
All Rights Reserved.
www.legrand.us