Network Connector; Control Button - Axis Q3505–VE User Manual

AXIS Q3505–VE Fixed Dome Network Camera
Hardware Overview

Network Connector

RJ45 Ethernet connector with Power over Ethernet (PoE).
NOTICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer's
instructions. For information about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, time lapse recording
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – An alarm input for connecting devices that can toggle between an open and closed circuit, for example:
PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes
active (shown under System Options > Ports & Devices).
Audio Connector
The Axis product has the following audio connectors:
• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
• Audio out (green) – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an
active speaker with a built-in amplifier. A stereo connector must be used for audio out.
SD Card Slot
A microSD card (not included) can be used for local recording with removable storage. For more information, see Technical
Specifications on page 63.
NOTICE TICE
NO NO TICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
Note
For SD card recommendations see www.axis.com

Control Button

The control button is used for:
• Resetting the product to factory default settings. See page 57.
• Connecting to an AXIS Video Hosting System service. See page 49. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 49. To connect, press and hold the button for about 3 seconds.
Function Button
The function button has multiple functions:
• As Levelling Assistant – This function helps to ensure the image is level. Press the button for about 2 seconds to start the
levelling assistant and press again to stop. The status LED (see page 8 ) and buzzer signal assist levelling of the image.
The image is level when the buzzer beeps continuously.
7