Control Button; Network Connector - Axis Q3517-LV Installation Manual

Buttons

Control button

For location of the control button, see Product overview on page 8.
The control button is used for:
• Resetting the product to factory default settings. See page 20.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see www.axis.com.
Function Button
The function button has multiple functions:
• As leveling Assistant – This function helps to ensure the image is level. Press the button
for about 2 seconds to start the leveling assistant and press again to stop. The status
LED (see ) and buzzer signal assist leveling of the image. The image is level when the
buzzer beeps continuously.
• To view the Status LED – Press the button once to light up the Status LEDs. Press again
to turn them off. The LEDs will turn off automatically after 10 seconds.
Connectors

Network connector

RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NO TICE NO TICE TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic compatibility (EMC) 4.
Audio connector
The Axis product has the following audio connectors:
• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
• Audio out (green) – 3.5 mm output for audio (line level) that can be connected
to a public address (PA) system or an active speaker with a built-in amplifier. It is
recommended to use a stereo connector for audio out.
AXIS Q3517–LV Network Camera
23
EN