Network Connector; Audio Connector - Axis Q16 Series Installation Manual

AXIS Q16 Network Camera Series
• Connecting to an AXIS Video Hosting System service. To find out more about this
service, see axis.com
Function button
The function button has multiple functions:
• Leveling assistant – This function helps to ensure the camera is level. Press the button
for about 3 seconds to start the leveling assistant and press again to stop the leveling
assistant. The status LED and buzzer signal assist leveling of the camera, see Status LED
behavior and buzzer signal for leveling assistant on page 15. The camera is level when
the buzzer beeps continuously.
• Focus assistant – This function is used for enabling the focus assistant. To enable the
focus assistant, press and very quickly release the button. Press again to stop the focus
assistant.
To find out more, go to page 11.
Connectors

Network connector

RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NO NO TICE TICE TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic compatibility (EMC) on page 4.

Audio connector

The Axis product has the following audio connectors:
• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
• Audio out (green) – 3.5 mm output for audio (line level) that can be connected
to a public address (PA) system or an active speaker with a built-in amplifier. It is
recommended to use a stereo connector for audio out.
3.5 mm audio
connectors (stereo)
16