Palette; Hide Graphics / Show Graphics; File - FLIR ThermaCAM B2 User Manual

10 – Camera program
When the scale is selected, you can change the emissivity directly by using the
■
navigation pad.
If you enter an emissivity value less than 0.30 the emissivity box will begin flashing
■
to remind you that this value is unusually low.
10.4.5
10382603;a4
Figure 10.12 Palette dialog box
Point to Palette on the vertical menu bar and press MENU/YES to display the Palette
dialog box.
To select another palette, press the navigation pad left/right
■
To confirm the choice, press MENU/YES
■
To cancel any changes, press PWR/NO
■
10.4.6
Point to Hide graphics on the vertical menu bar and press MENU/YES to hide all
graphics currently displayed on the screen. To display the graphics again, either:
Point to Show graphics on the menu, or
■
Briefly press SEL, or
■
Briefly press MENU/YES, or
■
Briefly press PWR/NO
■
➲ The laser icon overrides the Hide graphics menu selection. This means that even
though Hide graphics is selected when the Laser LocatIR is lit, the laser icon will still
be displayed on the screen.
10
10.4.7
10382903;a3
Figure 10.13 File menu
Figure 10.14 Explanations of the File menu
Command
Open
84

Palette

Hide graphics / Show graphics

File

Explanation
Point to Open and press MENU/YES to open the most recently saved
or viewed image.
To view another image, use the navigation pad to select the image.
Publ. No. 1557882 Rev. a156 – ENGLISH (EN) – February 28, 2006