Fitting The Fender; Fitting The Canopy - Flavel Emberglow FEBC00MN Installation And Maintenance Instructions Manual

AFTER THE PILOT FLAME HAS BEEN EXTINGUISHED, IF YOU WISH TO
RE-LIGHT THE APPLIANCE YOU MUST WAIT AT LEAST FIVE MINUTES
BEFORE TRYING TO RE-LIGHT THE APPLIANCE.
Finally, hand the Installation and Maintenance Instructions and the Users
Instructions over to the customer and explain the operation of the fire.
NOTE : THIS APPLIANCE IS DESIGNED TO WORK SAFELY AND
EFFECTIVELY DURING ADVERSE WEATHER CONDITIONS.
HOWEVER, DURING SUCH TIMES FLAME DISTURBANCE MAY BE
NOTICED. THIS IS NORMAL AND DOES NOT EFFECT OR IMPAIR
THE SAFETY OF THE APPLIANCE.
3.3 FITTING OF THE FENDER
Warning : Please take care whilst handling the fender as it's cast iron
construction means it is a heavy item that can be difficult to manoeuvere
a) Fit the fender by locating the two retaining brackets on the fender into
the slotted channel on the front of the combustion chamber
3.4 FITTING OF THE CANOPY
Warning : Please take care whilst handling the canopy as it's cast iron
construction means it is a heavy item that can be difficult to manoeuvere
a) The canopy is held in position by two off retaining screws at each side.
b) Fig. 16 below shows the position of the retaining screws for the canopy
Fig. 16
Supplied By www.heating spares.co Tel. 0161 620 6677
17