ASSEMBLING FUEL BED AND COMMISSIONING
3.1
FITTING THE FUELBED
a)
Place the fuel-bed rear section centrally in the combustion chamber as
shown below in Fig. 12
Fig. 12
b)
Fit the front ceramic coal form in front of the burner, as shown below in
Fig 13. Ensure that the front ceramic coal form is correctly located
behind the retaining brackets at the L/H & R/H ends.
Fig. 13
Supplied By www.heating spares.co Tel. 0161 620 6677
SECTION 3
Retaining brackets for rear coal form
14
Retaining brackets
for front coal form