Power Mode Switch - Emotiva Fusion Flex User Manual

Fusion Flex Amplifier
7. RS-232 Serial Remote Control Interface
Accepts RS-232 control codes from a wired serial remote control.
8. Trigger Input
The Trigger Input is used to allow other trigger-enabled equipment to switch the Fusion Flex
Amplifier between On and Standby.
9. IR Input.
Fusion Flex Amplifier
Connect an external IR sensor to this input if the is mounted such that IR
remote control signals cannot reach the front panel directly.

10. Power Mode Switch.

Selects between regular, triggered, and auto-on power modes.
Refer to the Installation Tips and Configuration sections for details.
11. Standard IEC Power Inlet.
Fusion Flex Amplifier
The requires a standard IEC C7/C8 (2.5A two wire) power cable.
Page 10