Speaker Terminals; Ac Power Switch - Emotiva XPA-200 User Manual

XPA-200
3. Trigger Input and Trigger Output
The XPA-200 is switched On (from Standby) when a trigger signal is presented at the
Trigger Input; the XPA-200 returns to Standby when the trigger signal is removed. When the
XPA-200 is on, a 12 VDC signal is sent from the Trigger Output to control other devices.
4. Status LED Switch
Disables the front panel status LEDs when set to Off.
5, 7. Unbalanced (RCA) Inputs and Balanced (XLR) Inputs
Solid machined gold-plated RCA jacks (1 per channel) accept line level unbalanced inputs.
Standard XLR connectors (1 per channel) accept line level balanced inputs.
6. Un-Balanced / Balanced Selector Switch
Switches between the Unbalanced (RCA) and Balanced (XLR) inputs for both channels.
Up selects the Unbalanced inputs and Down selects the Balanced inputs. Only one type of
input is active at once. (It is allowed to plug in both balanced and unbalanced sources and
use the switch to select between them, but only one will be active at once.)

8. Speaker Terminals

Full-sized, five-way binding posts accept banana plugs, lugs, or bare wire.

9. AC Power Switch

Switches the mains AC power to the XPA-200 On and Off. When this switch is Off, no
controls operate (the XPA-200 cannot be turned On from the front panel or by a trigger
signal).
10. Input Voltage Indicator
The XPA-200 automatically detects and switches between 115 VAC and 230 VAC. These
indicators tell you which line voltage the XPA-200 has detected.
11. IEC Power Cord Receptacle
Accepts a standard removable IEC AC power cable (a high-quality commercial power cable
is included).
Page 8