Basx A-800 Rear Panel; Power Mode Switch - Emotiva BasX A-800 User Manual

B X A-800 Multi-Zone Power Amplifier
AS
X A-800 Rear Panel
B
AS
1 2 3
BUS INPUT
- ON
R L
- AUTO
- TRIGGER
7
1. Status LEDs Switch
Disables the front panel status LEDs when set to Off.

2. Power Mode Switch

Note: The BaxX A-800 amplifier will only operate when the rear panel AC Power Switch is in the
On position. The BasX A-800 will always remain Off when the rear panel AC Power Switch is set
to Off.
The Power Mode Switch determines when the BasX A-800 will switch On and Off.
When the Power Mode Switch is set to On... when the rear panel AC Power Switch is set to On, the
BasX A-800 will go into Standby Mode for a few seconds, then turn itself On.
When the Power Mode Switch is set to Auto... when the rear panel AC Power Switch is set to On,
the BasX A-800 will go into Standby Mode. The BasX A-800 will turn On when an audio signal is
detected at any of the audio inputs. The BasX A-800 will remain On as long as an audio signal
is present; when no signal is present for several minutes, the BasX A-800 will return to Standby
Mode.
When the Power Mode Switch is set to Trigger... when the rear panel AC Power Switch is set to
On, the BasX A-800 will go into Standby Mode. The BasX A-800 will turn On when a trigger signal
is detected at the Trigger Input, and will return to Standby Mode when the trigger signal is no
longer present.
4
BUS BUS
ZONE 1 ZONE 2
Page 8
BUS BUS
ZONE 3 ZONE 4
5 6
A-800
8