Grandstream Networks GXV3240 Administration Manual page 66

Disable DND Reminder Ring
Disable Direct IP Call
Use Quick IP-Call mode
Disable Conference
Disable Transfer
Default Transfer Mode
Escape # as %23 in SIP URI
Offhook Auto Dial
Firmware Version 1.0.3.6
the indicator on the LCD screen for another incoming call. The default
setting is "No".
It is used to set if the phone system will play the DND reminder ringtone
for the incoming call if the DND feature is enabled. If it set to "Yes", the
phone will keep mute instead of playing a ring splash to indicate an
incoming call when DND is enabled.
The default setting is "No".
It is used to set if the phone system allows the end users to make an
outbound IP call. If it is set to "Yes", the phone will hide the IP call feature
and end users will not be allowed to make an outbound IP call. The
default setting is "No".
It is used to set if the phone system will automatically fills in the first
three octets to make an outbound IP call. If it is set to "Yes", users can
dial an IP address under the same LAN/VPN segment by entering the
last octet in the IP address. To dial quick IP call, offhook the phone and
dial #XXX (X is 0-9 and XXX <=255), the phone will make direct IP call to
aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP address
REGARDLESS of subnet mask. #XX or #X are also valid so leading 0 is
not required (but OK). No SIP server is required to make quick IP call.
The default setting is "No".
It is used to set if the phone system allows user to make a conference. If
it is set to "Yes", the phone will block the Conference application. The
default setting is "No".
It is used to set if the phone system allows user to transfer an active call
to another party. If it is set to "Yes", the phone system will block the
TRANSFER key on the LCD screen. The default setting is "No".
It is used to set the default transfer mode for the phone system.
If the Blind Transfer or Attended Transfer mode is set, the phone system
will use the specific mode to transfer an active call. The users still have
privilege to switch the mode on the LCD screen when they tap the
transfer key. The default setting is "Blind Transfer".
It is used to set what characters will be included in the SIP INVITE URI if
end users input #. If it is set to "Yes", the phone system will replace the #
by %23. Otherwise, it will include # in the SIP INVITE message. The
default setting is "Yes".
It is used to configure a User ID/extension to dial automatically when the
phone is offhook. The phone will use the first account to dial the
configured numbers out. The default setting is "No".
GXV3240 Administration Guide Page 64 of 105