Table of Contents
Advertisement
Communication settings for the serial console port are listed in
Table 1 Console Terminal Settings
Baud Rate
9600
AC PWR 90-228 V~, 500 mA: The AP can accept AC power at the limits specified on the unit. If the
AP-85FX/LX is not connected to a DC power source, the AP must be powered by an AC power
source. An outdoor rated, three-wire, 8-foot long AC power cable (wiring harness) is supplied with
the unit. For proper installation instructions, see
Grounding Point: It is important that the AP-85FX/LX be properly grounded; a grounding point is
provided on the bottom of the AP-85FX/LX model. The installer (trained service personnel) should
ensure that grounding is available and that the grounding meets applicable local and national
electrical codes.
Figure 7 AP-85FX/LX Bottom View
LED Status Indicators
All AP-85 models include visual indicators for power, link, and radio status. Additionally, each radio has
a seven-LED array that indicates received signal strength (RSSI).
N O T E
Table 2
Table 2 AP-85 LED Status Indicators
LED
PWR
LINK/ACT
(applicable to the
AP-85TX only)
12
| AP-85 Series Hardware Overview
Data Bits
8
The RSSI LED indicators represent varying degrees in the RSSI level. The absence of a signal is
indicated by no LED response, and full signal strength is indicated when all seven LEDs are active
and lit.
lists the meanings of the LEDs on the AP-85 outdoor access points.
Function
AP Power/Ready
Status
LAN/Network Link
Status
Parity
Stop Bits
None
1
DC and AC Power Cables on page
Indicator
Off
Flashing
On
Off
On (Yellow)
On (Green)
Aruba AP-85 Outdoor Access Point Series
Table
1.
Flow Control
None
30.
Grounding Point
Status
No power to AP
Device booting, not ready
Device ready
Ethernet link unavailable
10 Mbs Ethernet link negotiated
100 Mbs Ethernet link negotiated
| Installation Guide
Advertisement
Table of Contents
