Securing Appliance To Stove Pipe/Liner; Standard Surround & Cast Trim - Heatilator EcoChoice ECO-WINS18 Owner's Manual

D. Securing Appliance to Stove Pipe/Liner
1. Once you have the appliance in place and secured,
remove the tube channel assembly, baffl e board and
ceramic blanket. Detailed instructions are found on page
24.
2. Reach up through the fl ue opening and grab the attach-
ment bar and pull down inside fl ue opening. Figure 41.1.
3. Insert the 5/16 bolts inside the cast fl ue and through the
chimney mounting bar. Securely tighten the nuts. Fas-
teners are provided.
4. Re-install the tube channel assembly, baffl e board,
ceramic blanket and baffl e protection channel.
Attachment
Bar
5/16 Nuts
Figure 41.1
5/16 Bolts
Heatilator • ECO-WINS18 • 7065-132F • May 4, 2015
E. Standard Surround & Trim Kit Installation
Standard Size: 43 in. W x 31 in. H
Large Size: 51 in. W x 34 in. H
1. Lay surround face down on a protected surface to pre-
vent scratching.
2. Using a 4 to 6 inches long Phillips head screw driver
attach the side surrounds to the top surround using (2)
#8 sheet metal screws on each side provided with the kit.
Figure 41.2.
3. Lay the trim face down and place the corner brackets into
position.
4. Using a standard fl at screw driver tighten the corner
brackets. Figure 41.3.
5. Slide the assembled trim set over the surround set. and
then over the appliance matching the mounting tabs on
the side pieces with the slots on the appliance.
Secure 2 Side Surrounds to
Figure 41.2
Corner Brackets
Figure 41.3
Top Surround
41