Lights - Arctic Cat ZR 900 Series 2006 Operator's Manual

Overload Springs
Some models have overload springs
built into the rear suspension. When
either carrying a heavy load or
riding 2-up, the overload springs
should be engaged by rotating the
spring tension blocks to the UP posi-
tion. The spring tension blocks lock
in an over-center position when
engaged. To either engage or disen-
gage the spring tension blocks, use
the Spring Block Tool, a spark plug
socket, and a screwdriver to adjust
the spring block to the desired posi-
tion. Make sure both spring blocks
are in the same position (either
engaged or disengaged).

LIGHTS

The correct taillight/brakelight bulb
is p/n 0109-460. The correct head-
light bulbs are p/n 0609-251 for the
high beam and p/n 0609-252 for the
low beam.

NOTE: On the Crossfire/M-
Series models, the correct head-
light bulb for low beam is p/n
0609-693.
Removing and Installing
Taillight/Brakelight Bulb
1. Remove the screws securing the
taillight/brakelight lens; then
remove the lens.
MAINTENANCE
0739-625
2. Push in on the bulb and rotate it
counterclockwise to remove it
from the socket.
3. Install the new bulb in the
socket by pushing it in and
rotating it clockwise.
4. Install the lens and secure with
the screws.
0728-239
0737-302
0739-712
71