Arctic Cat ZR 900 Series 2006 Operator's Manual page 63

Removing Drive Belt (Standard
Driven Pulley)
1. Turn ignition key to the OFF
position and wait for all moving
parts to stop.
2. Set the brake lever lock.
3. Open the hood; then open the
belt guard.
4. Grasp the driven pulley roller
plate and push against it while
rotating it clockwise.
5. When the sheaves are fully
apart, hold the roller plate, pull
up on drive belt, and roll the
belt over the stationary sheave
until it is free of the driven pul-
ley. Slowly release the roller
plate.
62
0739-613
6. When the belt is free of driven
pulley, remove the belt from the
drive clutch.
Installing Drive Belt (Standard
Driven Pulley)
1. Place the belt (so the part num-
ber can be read) between the
sheaves of the drive clutch.
737-316A
2. Grasp the driven pulley roller
plate and push against it while
rotating it clockwise.
3. When the sheaves are fully
apart, hold the roller plate, roll
the belt over the stationary
sheave, and slowly release the
roller plate.
731-659A
737-317A
MAINTENANCE