Arctic Cat ZR 900 Series 2006 Operator's Manual page 33


NOTE: If the throttle control
lever operates properly and the
engine does not start, compress
the throttle lever slightly (approxi-
mately 1/8 throttle) and try start-
ing the engine. If the engine now
starts and stops when the throttle
lever is released, take the snow-
mobile to an authorized Arctic
Cat Snowmobile dealer for ser-
vice. If not under warranty, this
service is at the discretion and
e x p e n s e o f t h e s n o w m o b i l e
.
owner
! WARNING
If the throttle control lever does
n o t wo r k p ro p e r ly, D O N OT
AT T E M P T TO S TA R T T H E
ENGINE.
4. If the throttle control lever
operates properly, rotate the
ignition key to the RUN posi-
tion and go through normal
starting procedures.

NOTE: If the throttle control
lever operates properly and the
engine does not start, either a
malfunctioning monitor switch or
a misadjusted magnetic carbure-
tor switch (on twin VM-style car-
bu r e t o r m o d e l s ) m ay b e t h e
problem. Take the snowmobile to
an authorized Arctic Cat Snow-
mobile dealer for service. If not
under warranty, this service is at
the discretion and expense of the
.
snowmobile owner However, if a
dire emergency exists wherein
the engine must be started, dis-
connect the throttle control wiring
harness located below the han-
dlebar pad and next to the steer-
ing post. If disconnection of the
throttle control wiring harness is
needed to start the engine, take
the snowmobile to an authorized
Arctic Cat Snowmobile dealer for
service as soon as possible. If
not under warranty, this service is
at the discretion and expense of
the snowmobile owner
32
! WARNING
Under no circumstances should
disconnection of the throttle
control wiring harness be used
as a substitute for the monitor
switch during normal operation
of the snowmobile. Personal
injury and damage could occur
if the throttle system malfunc-
tions or if the operator is unable
to stop the engine in an emer-
gency. If the snowmobile must
b e o p e r a t e d w i t h a d i s c o n -
nected throttle control wiring
harness, EXTREME CAUTION
M U S T B E TA K E N . N E V E R
E XC EE D 1 0 M PH W I T H TH E
THROTTLE CONTROL WIRING
HARNESS DISCONNECTED.

NOTE: The monitor switch is
now bypassed. With exception of
the monitor switch and the emer-
gency stop switch, all other igni-
tion/ electrical features (ignition
switch, headlight, taillight, and
brakelight) will operate properly.
.
OPERATING INSTRUCTIONS
0734-481
738-156A