Download Print this page

Using Special Salt; Detergents With Salt Component; Softening System - Siemens SN series Operating Instructions Manual

Hide thumbs

Advertisement

Using special salt

Always refill with special salt
immediately before switching on the
appliance. This ensures that overrun
special salt solution is immediately
washed out and does not corrode the
rinsing tank.
1. Open the screw-type cap of the
compartment 1b.
2. Fill the tank with water (only required
when switching on the appliance for
the first time).
3. Then add dishwasher salt (not table
salt or tablets).
The water is displaced and runs out.
As soon as the salt refill indicator H
on the fascia is lit, top up the salt.
* depending on model
Water softening system/Special salt
Using detergents with salt
component
If combined detergents with a salt
component are used, salt can usually be
omitted up to a water hardness of
21° dH (37° fH, 26° Clarke, 3.7 mmol/
l). If the water hardness is over 21° dH,
special salt must be used.
Switching off salt refill
indicator/water softening
system
S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m
If the salt refill indicator H is impaired
(e.g. when using combined detergents
containing salt component), it can be
switched off.
Proceed as described under
"Adjusting the water softening
system" and set the value to :
The water softening system and salt
refill indicator are now switched off.
m
Caution
Never fill the salt dispenser with
detergent. You will destroy the water

softening system.

D e t e r g e n t s w i t h s a l t c o m p o n e n t
en
.
11

Advertisement

loading

This manual is also suitable for:

Sx series