Switching On The Appliance; Optical Display While The Programme Is Running - Siemens SN series Operating Instructions Manual

en Operating the appliance
m
Warning – Risk of injury!
Do not touch the blow opening 1R. The
blow opening becomes hot and,
furthermore, any damage will result in
a chargeable callout by customer
service.

Switching on the appliance

1. Turn on the tap fully.
2. Open the door.
3. Switch on ON/OFF switch (.
The Eco 50° programme display
flashes. This programme remains
selected if no other programme
button 0 is pressed. The expected
programme duration
flashes on the digital display 8.
4. Press the START button )".
5. Close the door.
The programme starts running.
Note
- for environmentally friendly operation
of the dishwasher:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
"Standard programme" which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
22
Optical display while
the programme is running *
* depending on model
While the programme is running,
an optical display is indicated
on the floor under the appliance door.
If the base panel is pulled forwards
or if the appliance is installed at eye-
level with flush furniture front, the display
is not visible.
Possible settings of the optical
display:
: The display is switched off.
: Programme, timer programming,
remaining time, end of programme
and, if required, low water level are
displayed.
: Same as :
information is also displayed,
e.g. the symbol for half load §
or glass protection system
active W.
: is set at the factory.
To change the setting:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )"
until : .... is indicated on the digital
display.
4. Release both buttons.
The illuminated display of the
button # flashes.
5. Keep pressing programme
button # until the previously set
value, e.g. :
digital display 8 : ... (for the
optical display).
. Other programme
, is indicated on the
O p t i c a l d i s p l a y w h i l e t h e p r o g r a m m e i s r u n n i n g