Download Print this page

Siemens SN series Operating Instructions Manual page 31

Hide thumbs


Utensils not dry.
Plastic utensils not dry.
Cutlery not dry.
Appliance interior wet after
rinse cycle.
No or too little rinse aid
in the dispenser.
Programme selected without
Water collecting in depressions
on the utensils and cutlery.
The combined detergent used
has a poor drying performance.
Intensive drying to increase
drying not activated.
Utensils were removed too early
or drying process had not ended
The eco rinse aid used has a poor
drying performance.
Special properties of plastic.
Cutlery not arranged properly
in the cutlery basket.
Cutlery not arranged properly
in the cutlery drawer.
No appliance fault.
Fault, what to do?
Remedial action
Refill rinse aid.
Select programme with drying (see
Overview of programmes, Programme
Arrange utensils in a sloping position,
arrange affected utensils as sloping
as possible.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Activate intensive drying (see Operating
the appliance)
Wait until program ends or wait until 30 min
after program ends before removing
Use a proprietary rinse aid. Eco products are
much less effective.
Plastic has a lower heat storage capacity
and therefore dries less well.
Separate cutlery if possible, prevent contact
Arrange cutlery properly and separate if
On account of the "Condensation drying"
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.



This manual is also suitable for:

Sx series