Table of Contents
Advertisement
VISTA-50P/VISTA-50PUL Installation and Setup Guide
Changing a Master, Manager, or Operator Code
Enter Installer Code * + [8] + new user no. (02-75) + new user's code
* Or Master or Manager Code, but the code must be a higher level of authority than the code being changed (e.g. a
Manager Code can add an Operator-level Code, but cannot add a Master or another Manager Code).
PROMPT
User Number = 03
NEW USER?
Adding an RF Key to an Existing User
To add an RF key to an existing user, or to change a user's global arm option, first delete that user's code, then re-add
the user code as described in the "Adding a Master, Manager, or Operator Code" paragraph.
Deleting a Master, Manager, or Operator Code
Enter your code * + [8] + new user no. (02-75) + your code again
* Or Master or Manager Code, but the code must be a higher level of authority than the code being changed (e.g. a
Manager Code can add an Operator-level Code, but cannot add a Master or another Manager Code).
PROMPT
OK TO DELETE 03?
0=NO
1=YES
A user code can be deleted only from the partition through which it was entered. If an attempt is made to
delete from another partition, the message "User [XX] Not Deleted" is displayed.
Exiting the User Edit Mode
Press either [7] or [#], or don't press any key for 10 seconds.
9-4
EXPLANATION
The system detects that the user number is already assigned, and prompts if this is a new user.
Press 0 (NO).
The system then confirms that the change is allowed based on authorization level.
EXPLANATION
The system prompts to confirm that you want to delete this user. Press 0 (NO) or 1 (YES).
If you answered "yes," that user's code is removed from all partitions to which it was assigned, and all
authorization levels and other information about that user are deleted. Note that a user can be deleted only
by a user with a higher authority level. A user cannot delete himself.
WWW.DIYALARMFORUM.COM
Advertisement
Table of Contents
