Changing A Master, Manager, Or Operator Code; Deleting A Master, Manager, Or Operator Code; Exiting The User Edit Mode - Honeywell VISTA-128FBPN Installation And Setup Manual

VISTA-128FBPN Installation and Setup Guide
PROMPT
XMT USER DATA
1 = YES 0 = NO
INDV USER PGM
1 = YES 0 = NO
Part. 1 A0* WHSE
User 003 Auth=3G.

Changing a Master, Manager, or Operator Code

Enter Installer Code * + [8] + new user no. (002-150) + new user's code
* Or Master or Manager Code, but the code must be a higher level of authority than the code being changed (e.g. a
Manager Code can add an Operator-level Code, but cannot add a Master or another Manager Code).
PROMPT
User Number = 003
NEW USER?

Deleting a Master, Manager, or Operator Code

Enter your code * + [8] + new user no. (002-150) + your code again
* Or Master or Manager Code, but the code must be a higher level of authority than the code being changed (e.g. a
Manager Code can add an Operator-level Code, but cannot add a Master or another Manager Code).
PROMPT
OK TO DELETE 003?
0=NO 1=YES
A user code can be deleted only from the partition through which it was entered. If an attempt is made to
delete from another partition, the message "User [XXX] Not Deleted" is displayed.

Exiting the User Edit Mode

Press either [T] or [#], or don't press any key for 10 seconds.
9-4
EXPLANATION
If the user number is from 001-050 this appears. Answer YES (1) to have the system send the
user's attributes to all the other control panels that are "linked" to this control. If you answer NO
(0), the system displays the following prompt on the next page.
Answer YES (1) to link to another control panel and manually enter the user into partition(s) in
that control panel. If you answer NO (0), the system scrolls through each partition displaying a
summary of the user's attributes in each partition (see next prompt).
Note that the "G" following the authority level indicates that the global arm feature is enabled for
this user in the displayed partition, and that the period at the end of the second line indicates
Open/Close reporting is enabled for this user in the displayed partition. The "T" indicates the
partition from which the user may be changed or deleted.
EXPLANATION
The system detects that the user number is already assigned, and prompts if this is a new user.
Press 0 (NO).
The system then confirms that the change is allowed based on authorization level.
EXPLANATION
The system prompts to confirm that you want to delete this user. Press 0 (NO) or 1 (YES).
If you answered "yes," that user's code is removed from all partitions to which it was assigned,
and all authorization levels and other information about that user are deleted. Note that a user
can be deleted only by a user with a higher authority level. A user cannot self delete.