Using Your Blender In Manual Mode; Using Your Blender In Automatic Mode - Wolfgang Puck BEBB0030 Use And Care Manual

Using Your Blender in
Manual Mode
1 Put ingredients in jar. Always add liquid ingredients first followed by
solid ingredients.
2 Place the filler cap insert into the blender lid opening and turn filler cap
clockwise until tight. Firmly attach assembled lid to the blender jar.
3 Plug the blender into a 120-volt 60 Hz AC-only outlet. Place the blender
jar on the motor base. All icons will display briefly for 1 second and the
blender will be in stand-by mode. The timer will display "00:00".
4
The timer display shows elapsed time.
5
This blender has 10 speeds plus a Pulse function. Select the speed that
best suits your blending task. We recommend always starting on Low
speed and gradually increase to your desired speed. The speed range
low to high can be set by sliding your finger from the lowest speed
bar to the highest. The speed can also be adjusted when the blender is
operating.
6 When the SPEED has been set, touch the START/CANCEL icon to start
blending. The color of the icon will change from red to white. To turn off
the blender, touch the START/CANCEL icon while blending. The blender
will turn off and the START/CANCEL icon will change back to a red
color.
7
To add ingredients while the blender is on, remove the filler cap insert
and drop ingredients through the lid opening. Replace the filler cap
securely when done. Do not place your hands into the blender jar with
the blender plugged in.
8
The blender can also be used in PULSE mode without setting the
SPEED. To use the PULSE mode, touch the PULSE icon once to activate
the PULSE mode (the light will be blinking). Touch and hold the PULSE
icon within 5 seconds to start blending in PULSE mode. To stop the
PULSE mode, simply release the PULSE icon. The blender always
operates on the highest speed in PULSE mode regardless of the preset
program selected. When using the PULSE mode, the timer will display
"00:00" and show elapsed time when in operation.
WARNING: When blending hot liquids ensure the lid is securely in place.
Place the filler cap into lid and turn clockwise until it stops (about a
quarter turn). Always start in low speed and then increase speed to
desired setting. Use caution with hot liquids. Spraying from under the
filler cap can occur, or escaping steam may cause scalding. Only use the
lid provided with your blender.
8
Using Your Blender in
Automatic Mode
Your blender has 6 preprogrammed modes that automatically set the
speed and blending cycle. See reference chart below. Follow the below
instructions to use automatic mode.
1 Put ingredients in the Blender Jar. Always add liquid ingredients first
followed by solid ingredients unless a recipe states otherwise.
2 Place the filler cap insert into the blender lid opening and turn filler cap
clockwise until tight. Firmly attach assembled lid to the blender jar.
3 Plug the blender into a 120-volt 60 Hz AC-only outlet. Place the blender
jar on the motor base. All icons will display briefly for 1 second and the
blender will be in stand-by mode. The timer will display "00:00".
4 Select the desired preset program selection then touch the START/
CANCEL icon. The blender will run in the mode according to the
selected program. To stop the blender at any time during operation,
touch the START/CANCEL icon and the blender will go back to standby
mode.
5
9