Installing The Battery; Removing The Hard-Drive Assembly - Dell Latitude E5450 Owner's Manual

a. Remove the screws that secure the battery to the computer [1].
b. Lift and push to remove the battery from the computer [2] [3].

Installing the Battery

1. Insert the battery into its place on the computer.
2. Route the battery cable through its routing channel.
3. Tighten the screws to secure the battery to the computer.
4. Connect the battery cable to its connector on the system board.
5. Install the base cover.
6. Follow the procedures in

Removing the Hard-Drive Assembly

1. Follow the procedure in
2. Remove the:
a. base cover
b. battery
3. Perform the following steps:
a. Disconnect the hard-drive cable from its connector on the system board [1] .
b. Remove the screws that secure the hard-drive assembly to the computer [2].
10
After Working Inside Your
Before Working Inside Your
Computer.
Computer.