Table of Contents
Advertisement
5.4.1
Line Selector
In the Line Selector, the following input and output signals can be assigned.
Table – 7 Line selector
Line Selector item
Line 2 OPT Out1
Line 3 OPT Out2
Line 8 TTL 2 Out
Line 9 TTL 3 Out
NAND 0 In 1
NAND 0 In 2
NAND 1 In 1
NAND 1 in 2
Note: Line 8 and 9 are available if AUX Type 3 is used for AUX connector (option).
5.4.2
Line source
Line source signal is selected against the dedicated line selected in the line selector.
Table – 8
Line source
Line Source item
Low
High
Frame Trigger Wait
Frame Active
Acquisition Trigger Wait
Acquisition Active
Exposure Active
FVAL
LVAL
PulseGenerator0 Out
PulseGenerator1 Out
PulseGenerator2 Out
PulseGenerator3 Out
Line 5 Opt In 1
Line 6 Opt In 2
NAND 0 Out
NAND 1 Out
Line 10 TTL 2 In
Line 11 LVDS 1 In
Note: As for LVAL, some line items cannot be connected. Refer to "5.4.7.2 GPIO matrix table"
EL-2800M-GE2 / EL-2800C-GE2
Description
Opt 1 output from 12P connector #9/10 pin located on the rear panel
Opt 2 output from 12P connector #7/8 pins located on the rear panel
TTL 2 output from "AUX" HIROSE 10-Pin connector #1 pin
TTL 3 output from "AUX" HIROSE 10-Pin connector #2 pin
NAND first gate, No. 1 input on GPIO
NAND first gate, No. 2 input on GPIO
NAND second gate, No. 1 input on GPIO
NAND second gate, No. 2 input on GPIO
Description
Connect Low Level signal to line item selected in Line Selector, Default setting
Connect High Level signal to line item selected in Line Selector
Connect Frame Trigger Wait signal to line item selected in Line Selector
Connect Frame Active signal to line item selected in Line Selector
Connect Acquisition Trigger Wait signal to line item selected in Line Selector
Connect Acquisition Active signal to line item selected in Line Selector
Connect Exposure Active signal to line item selected in Line Selector
Connect FVAL signal to line item selected in Line Selector
Connect LVAL signal to line item selected in Line Selector
Connect Pulse Generator 0 signal to line item selected in Line Selector
Connect Pulse Generator 1 signal to line item selected in Line Selector
Connect Pulse Generator 2 signal to line item selected in Line Selector
Connect Pulse Generator 3 signal to line item selected in Line Selector
Connect Opt In 1 signal to line 5 in Line Selector
Connect Opt In 2 signal to line 6 in Line Selector
Connect NAND 0 signal to line item selected in Line Selector
Connect NAND 1 signal to line item selected in Line Selector
Connect TTL 2 In signal to Line 10
Connect LVDS 1 In signal to Line 11
- 33 -
Advertisement
Table of Contents
