Differential Assembly - Shibaura CM214 Workshop Manual

4) Differential Assembly

(1) Disassembly
1. If installed, remove the bearings ➀.
2. Remove the bolts ➁, and separate the ring gear ➂
from the differential housing ➃.
3. Remove the thrust washer ➄ and differential gear
➅.
4. Remove the pin ➆ from in the differential housing
➃.
5. Draw out the pinion shaft ➇ and remove the
thrust washers ➈, pinion gear ➉, thrust washer
⑪ and differential gear ⑫ from in the differential
housing ➃.
(2) Assembly
Reassembly generally follows the disassembly
procedure in reverse.
During assembly observe the followings:
1. Install the ring gear bolts with two lock washers
(No. 399310270), and tighten to specified torque.
NOTE: The lock washers are installed reassembly
only.
Ring gear tightening torque
25.5 ± 2.9 N·m {2.6 ± 0.3 kgf·m}
2. Bend the lock washers at the three positions of each
one.
3. If new differential components are used, adjust the
backlash and ring gear contact patterns as follows:
a. Install the
"TRANSMISSION
ASSEMBLY" in this section.
b. Using prussian blue on the pinion gear teeth.
c. Install the differential gear assembly and both
wheel shaft assemblies on the transmission
housing.
d. Place the dial indicator at a right angle to the
top of a ring gear tooth.
e. Rock the ring gear back and forth and observe
the dial indicator reading.
drive pinion refer
AND FRONT AXLE
to
78
432V
433V
434V