Differential Ass’y; Clearance Between Pinion Shaft And Differential Pinion (Mm) - Shibaura ST333 Workshop Manual

5) Differential ass'y
Refer to paragraph of transmission (rear differential).
Components
1. Bearing（6008）
2. Bolt
3. Differential cage（cover）
4. Thrust washer
5. Differential gear
NOTE:
Coating bolts are used to tighten the ring gear in the
factory (without lock washer). Bolts and lock washers are
available as service parts to be used for reassembly. Use
them and tighten with the specified torque. When reusing
the bolts, remove oil and stain and tighten using lock
washer without fail.
Ring gear tightening torque
N·m {kgf·m}
6. Thrust washer
7. Gear ass'y
8. Lock washer
9. Pinion shaft
10. Pinion shaft
49－62.7
{5.0－6.4}
318-1Y
70
11. Bevel gear
12. Clip
13. Differential cage (main body)
14. Bolt
15. Bearing (6208)
(1) Replace the thrust washer of the differential pinion if
the service limit is exceeded.
(2) Replace the pinion shaft and differential
clearance exceeds the service limit.
Clearance between pinion shaft and differential
pinion (mm)
Standard dimension
0.03 – 0.1
318Y
pinion if their
Service limit
More than 0.5