Rear Axle Assembly; Removal; Disassembly - Shibaura CM214 Workshop Manual

3-2 Rear Axle Assembly

1) Removal

1. Oil hose
Disconnect the oil hoses from the power steering
cylinder.
2. Rear axle assembly
a. Pull up and hold the engine by hoist.
b. Remove the bolts ➀ for fixing the front
bearing holder ➁ and rear bearing holder , ➂
and remove the rear axle assembly from the
frame.

2) Disassembly

1. Remove the rear wheels.
2. Remove the tie rod ➀ from the both mission cases
➁.
3. Remove the power steering cylinder ➂ from the
front axle assembly.
4. Remove the case cover ➃ with wheel shaft ➄,
bearings ➅ and ➆, oil seal ➇, snap ring ➈
and final gear ➉ as a set.
5. Remove the bearing ➅ and final gear ➉ from
the wheel shaft ➄.
6. Remove the snap ring ➈ and bearing ➆, oil seal
➇ and wheel shaft ➄ from the case cover ➃.
7. Ply the seal covers ➀ and ➁ from top of the
idler mission case ➂ and bottom of mission case
➃ by screw driver and discard them.
8. Remove the snap ring ➄ from in the idler mission
case ➂.
9. Drive out the idler drive shaft ➅ and idler gear ➆
with bearing ➇ from in the idler mission case ➂.
10. Remove the final pinion ➈ and bearing ➉ from
in the mission case ➃.
Remove the snap ring ⑪ and spacer ⑫ from the
idler mission case ➂, and remove the mission case
➃ with bearing ⑬ and oil seal ⑭ from the idler
mission case ➂.
93
455V
456V
457V