Front Wheel Shaft - Shibaura CM214 Workshop Manual

5) Front Wheel Shaft

(1) Disassembly
1. Remove the snap ring (1) from the wheel shaft.
2. Drive out the wheel shaft (2).
3. Remove the bolts, and take out the bearing carrier (3), brake discs (4), stator (5), plate (6) and balls from in the
wheel shaft housing (7).
4. Remove the snap ring (8) and brake lever (9) from the housing.
5. If necessary, remove the oil seal (10) and bearing (11) from the housing.
(2) Inspection, Service and Assembly
Inspection
➀ Disk
Measure the lining thickness and replace if the
measurement is below the service limit.
➁ Stator
Replace the stator if the lining-contact surface is
roughened or the difference of level height is more
than 0.1 mm.
➂ Check the brake cover, steel ball, brake cam, and
spring and replace defective ones.
Reassembly
Reassembly generally follows the disassembly procedure
in reverse.
Standard dimension
2.8 mm
Level height difference of contact surface
Service limit
80
436V
Service limit
2.5 mm
0.1 mm