Connecting The Power Cable; Turning The Power On - Star SP6000 SERIES Hardware Manual

3-3. Connecting the Power Cable

Note: Before connecting or disconnecting the power cable, make sure that the printer and all the devices connected
to it are turned off.
(1) Connect the power cable to the connector on the printer.
Note: Use the power cable included with the printer.
(2) Insert the power cable plug into the outlet.
Note: • The included power cable is for exclusive use with this product.
Rated voltage: 100 – 240 V (Inlet type). Frequency: 50/60 Hz
• Take into consideration the noise in the environment that the printer is installed in, and take appropriate
measures to protect the printer from static electricity, AC line noise, etc.

3-4. Turning the Power On

Connect the power cable according to the procedure in section 3-3, "Connecting the Power Cable".
Turn on the power switch on the right side of the printer.
he POWER lamp on the control panel will flash. (No paper status)
- 5 -