4-1. Name of each part
POWER lamp
4-2. Features according to Panel Buttons
Refer to the following table.
The meanings of the symbols are as follows, ○: press the button, l: hold down the button. When both symbols are shown,
press the ○ button while the l button is held down.
SET/EJECT
Printer status
button
ON-LINE
○
OFF-LINE
○
○
○
l
Power is turned
on while pressed
l
< During Auto Loading Position Change Mode >
SET/EJECT
FEED
button
button
○
○
4. Control Panel
MODE lamp
SET/EJECT button
FEED button
FEED
ONLINE
button
○
○
l
○
l
○
l
ONLINE
button
Resets the feeding position to its factory default position, and then exits.
l
Saves the new feeding position, and then exits.
l
ONLINE button
button
○
Switches to off-line.
Feeds paper to the cut position after printing with continuous paper is
complete.
Switches between high-speed and high-precision.
○
Switches to on-line.
Performs a line feed.
Inserts/ejects continuous paper or ejects cut paper.
○
Feeds paper (page break).
Feeds paper slightly in the feeding direction.
l
Feeds paper slightly in the reverse direction.
l
Changes the auto loading position (see table below).
Sets the current paper position as the feeding position.
Self-printing (Firmware version, Memory switch setting status)
l
Self-printing (Firmware version, Rolling ASCII <7 lines>, All ASCII
<Draft/Courier: 10 cpi, 12 cpi, proportional>, All kanji)
Hex dump mode: All signals sent from the host computer to the printer
are printed in hexadecimal code.
Functions
- 13 -
ONLINE lamp
Functions