Led Indications; Error Indications - Star SP6000 SERIES Hardware Manual

4-3. LED Indications

4-3-1. Normal status
If an error is detected, check the recovery conditions. Recovery is possible without changing the status of the printer.
Status
Status
Offline
High Quality Mode
High Speed Mode
Paper Out
Head high temperature
detection

4-3-2. Error Indications

Turn off the printer, check the recovery conditions, and then turn on the printer again.
If the same error occurs after restarting the printer, repairs are necessary.
Error description
Watchdog Timer
Mechanical Error
Head Thermistor error
PCB Thermistor error
Power voltage down
FLASH Access Error
RAM Access Error
Firmware Error
Note 1: If an unrecoverable error occurs, turn off the printer as quickly as possible.
2: If a power supply voltage error occurs, a power supply fault may be the cause of the error.
3: If paper is jammed, turn off the printer, remove the jammed paper, and then turn on the printer again.
If another type of unrecoverable error occurs, consult your dealer for repairs.
POWER MODE
ON -
ON -
ON OFF
ON ON
Flashing 1 Sec. -
ON -
POWER
Flashing 0.5 Sec.
Flashing 0.5 Sec.
Flashing 0.5 Sec.
Flashing 0.5 Sec.
Flashing 0.5 Sec. Flashing 0.5 Sec.
Flashing 0.5 Sec. Flashing 0.5 Sec.
Flashing 0.5 Sec. Flashing 1 Sec.
Flashing 0.5 Sec. Flashing 1 Sec.
ONLINE
ON -
OFF -
- -
- -
The printer recovers when you set a new paper roll
OFF
and close the cover.
The printer recovers automatically when the ther-
Flashing 1 Sec.
mal head cools.
MODE ONLINE
OFF OFF
ON OFF
OFF ON
OFF Flashing 0.5 Sec.
OFF
Flashing 0.5 Sec.
OFF
Flashing 1 Sec.
- 14 -
Recovery condition
Cause
Watchdog Timer time up
Mechanical failure
Head Thermistor Detected Erroneous Value
PCB Thermistor Detected Erroneous Value
ower Voltage Error Value Detected
FLASH ROM Access Problem
RAM Access Problem
-