Table of Contents
Advertisement
1-1. Unpacking
After unpacking the unit, check that all the necessary accessories are included in the package.
Printer
1-2. Notes about Installation
1. Choose a firm, level surface where the printer will not be exposed to vibration.
2. Make sure that the printer is connected to a reliable power outlet. It should not be on the same electric circuit as copi-
ers, refrigerators, or other appliances that cause power spikes.
3. The power outlet you plan to connect to for power should be nearby and unobstructed.
4. Make sure that the printer is not exposed to direct sunlight.
5. Make sure that the printer is well away from heaters and other sources of extreme heat.
6. Do not locate the printer in a badly ventilated or dusty environment.
7. Make sure that the room where you are using the printer is not too humid.
8. Use the printer within the boundaries indicated in the environmental requirements. Even when the ambient tem-
perature and humidity are within the specifications, avoid radical changes in environmental conditions. The suitable
operating temperature range is as follows:
Temperature
Humidity
9. When disposing of the printer, obey local regulations.
1. Unpacking and Installation
Operating: 0°C to 35°C
Stand-by: -30°C to 65°C
Operating: 30% to 80%
Stand-by: 20% to 90%
Ribbon Cartridge
Holding plate
* Accessories vary depending on the model and the
region where the printer was purchased.
- 1 -
CD-ROM
Safety Instructions
Advertisement
Table of Contents
