General Lubrication - Arctic Cat 2012 XC 4501 Operator's Manual


NOTE: Before attempting to adjust suspension, clean dirt
and debris from the sleeve and remove load from the sus-
pension; then use the spanner wrench to adjust the sleeve
to the desired position.
Position Spring Force
1
2
3
4
5
Stronger

General Lubrication

Cables
None of the cables require lubrication; however, it is advisable to
lubricate the ends of the cables periodically with a good cable lubri-
cant.
Engine/Transmission Oil and Filter

NOTE: Refer to the recommended oil viscosity chart (on
page 44) in this manual for the proper engine oil.
Change the engine oil and oil filter at
the scheduled intervals. The engine
should always be warm when the oil
is changed so the oil will drain easily
and completely.
1. Park the ATV on level ground.
2. Remove the oil level stick. Be
careful not to allow contami-
nates to enter the opening.
48
Setting Load
Soft Light
Stiff Heavy
KC0051A
3. Remove the drain plug from
the bottom of the engine and
drain the oil into a drain pan.
4. Remove the oil filter plug from
the filter mounting boss
(located on the front-right side
of the transmission case) and
allow the filter to drain com-
pletely.
5. Using the oil filter wrench and a ratchet handle (or a socket or
box-end wrench), remove the old oil filter and dispose of prop-
erly. Do not re-use oil filter.

NOTE: Clean up any excess oil after removing the filter.
6. Apply oil to the new filter O-ring and check to make sure it is
positioned correctly; then install the new oil filter. Tighten
securely.
7. Install the oil filter drain plug and tighten securely.
8. Install the engine drain plug and tighten it securely. Pour the rec-
ommended oil in the filler hole. Install filler plug.
9. Start the engine (while the ATV is outside on level ground) and
allow it to idle for a few minutes.
10. Turn the engine off and wait approximately one minute. Recheck
the oil level.
11. Inspect the area around the drain plug and oil filter for leaks.
Front Differential and Rear Drive Gear
Lubricant (Inspecting/Changing)
Inspect and change the gear lubricant in each according to the Main-
tenance Schedule. When changing the lubricant, use approved SAE
80W-90 hypoid oil and use the following procedure.
1. Place the ATV on level ground.
733-441A