Mounting Instructions - Dometic RM2620 Installation And Operating Instructions Manual

INSTALLING THE DOOR PANELS
The refrigerator is normally delivered without door panels.
Before starting the mounting work, read this instruction thor-
oughly and check that the panel dimensions are in compliance
with those given in the "Panel dimensions" table.
Panel dimensions
max. thickness 5/32" (4 mm)
Refrigerator
model
max
RM2620
upper mm 306
inch 12-3/64
lower mm 819
inch 32-1/4
RM2820
upper mm 378
inch 14-7/8
lower mm 897
inch 35-5/16
To install the door panels, follow these steps:
1. Open the door 90 degrees.
2. On new refrigerators, the decoration strips are taped
inside the door; if installed on the door, remove
the door decoration strip (2) by removing its two
screws (1).
3. Insert one vertical edges into the groove of the door
frame (3).
4. Bend the panel gently so that the free side of the
panel can be slipped into the corresponding groove
of the door frame (4).
5. Slide the panel down into the groove of the bottom
frame (5).
6. Put the decoration strip across the door so that the
gap between the upper edge of the panel and the
door frame is covered and then, push it upward (6).
The tabs on the inside of the strip should fit behind
the flange of the door frame.
7. Secure the decoration strip with the two screws
removed in step 1.

MOUNTING INSTRUCTIONS

Height Width
min max
304 515 513
11-31/32 20-9/32 20-13/64
817 515 513
32-5/32 20-9/32 20-13/64
376 563 561
14-51/64 22-11/64 22-3/32
895 563 561
35-15/64 22-11/64 22-3/32
min
- 9 -
1
2
1
4
3
5
6
1
1