Figure 6-42: Adapters; Figure 6-43: Select Network Adapter; Figure 6-44: Insert Disk - Cisco Linksys LNE100TX User Manual

EtherFast 10/100 LAN Card
Installing the LAN Card's Driver if Networking is Already Installed
The following steps are for NT PCs that have networking already installed according to the Windows NT
documentation. If you have not already installed networking onto your NT PC, please refer to your Windows
documentation. These steps will install the EtherFast® 10/100 LAN Card's driver software on your PC, enabling
your PC to properly communicate with the Adapter. Remember that you must be logged on as a network
administrator to continue.
1. Click on Start, Settings, Control Panel, then double-click on the Network icon.
2. When the networking window appears, choose the Adapters tab, as shown in Figure 6-42, and click the Add
button.
3. When the list of available network adapters appears, as shown in Figure 6-43, click the Have Disk button.
4. Put the LNE100TX 10/100 LAN Card Setup Utility CD into your CD-ROM drive. Type D:\, as shown in Figure
6-44 into the field and click the OK button.
Chapter 6: Manual Installation and Setup
Windows NT

Figure 6-42: Adapters

Figure 6-43: Select Network Adapter

Figure 6-44: Insert Disk

30