Table of Contents
Advertisement
EtherFast 10/100 LAN Card
Refer to the Troubleshooting section if:
• You don't see anything at all in Network Neighborhood and have pressed the F5 key on your keyboard a
few times to refresh the screen.
• You only see your own computer in Network Neighborhood.
• You see all computers on the network except yours and have tried pressing the F5 key a few times.
• You only see computers that are running the same operating system as you and you don't see any others.
Windows ME
1. Start up your PC in Windows ME.
2. Windows ME will automatically detect the presence of the PCI Ethernet Controller hardware in your PC.
3. Insert the LNE100TX 10/100 LAN Card Setup Utility CD into your CD-ROM drive while the Add New Hardware
Wizard window is visible. Click the Next button.
4. Click the Specify the location of the driver (Advanced) radio button on the screen shown in Figure 6-22.
Then, click the Next button.
Chapter 6: Manual Installation and Setup
Windows ME
Figure 6-22: Specify the Location
21
Advertisement
Table of Contents
