Figure 6-36: Manually Select An Adapter; Figure 6-37: Tcp/Ip Protocol; Figure 6-38: Copy Files - Cisco Linksys LNE100TX User Manual

EtherFast 10/100 LAN Card
7. The adapter will be added to the list of Network Adapters on the Network Setup Wizard screen, shown in
Figure 6-36. Click the Next button.
8. Make sure there is a check mark beside TCP/IP Protocol, as shown in Figure 6-37. Uncheck any others that
may be checked, then click the Next button to continue.
9. Click the Next button to proceed through the subsequent screens. If you are asked to supply your original
Windows NT CD-ROM or setup disks, as shown in Figure 6-38, place your Windows NT CD-ROM in your CD
drive. If the CD-ROM loads a pop-up window, close it. Type D:\i386 (where D: represents your CD-ROM drive)
in the field at the bottom of the window. Click the Continue button.
Chapter 6: Manual Installation and Setup
Windows NT

Figure 6-36: Manually Select an Adapter

Figure 6-37: TCP/IP Protocol

Figure 6-38: Copy Files

28