Operator Error Message Table - Lexmark Optra N 4040-FIN Service Manual

4040 Finisher

Operator Error Message Table

If you have a paper jam, be sure to clear all paper from the finisher,
paper deck, and printer. If you are unable to clear an operator error
code for a paper jam; note the location of the paper jam and check
the paper sensor for that station. See
"Sensors" on page
"Service Checks" on page 2-10
paper is present you must open a finisher cover to clear the error
code.
Message
30 Finisher Door Open (MS1,
MS7)
31 Finisher Interlock Open (PI-15)
41 Paper Jam (PI-1)
42 Paper Jam (PI-2)
2-3
4-5. If the sensors are working properly, see the
for other mechanical failures. If no
Action
Be sure the finisher top cover, right
access door, and stapler access
door are completely closed. If the
error does not clear, check the door
switches and replace if necessary.
Be sure the finisher is positioned
snugly against the printer and the
latches on either side of the finisher
are snapped in place. If the error
does not clear, check the interlock
sensor. Replace if necessary.
There is a paper jam in the input
area, right access door. If the error
code does not reset after you clear
the paper jam, go to the
41, Paper Input Service Check" on
page
after that, go to the
on page
There is a paper jam at the right
access door. If the error code does
not clear after you clear the paper
jam, go to the
Reversing Paper Sensor Service
Check" on page
a problem after that, go to the
"Symptom Table" on page
"Switches" on page 4-4
2-12. If there is still a problem
"Symptom Table"
2-7.
"Paper Jam, 42,
2-13. If there is still
or
"Paper Jam,
2-7.