Stapler Motor Service Check; Stapler Shift Motor Service Check - Lexmark Optra N 4040-FIN Service Manual

4040 Finisher

Stapler Motor Service Check

1 Connector
2 Stapler Motor
3 Finisher Driver
Board (13-1)

Stapler Shift Motor Service Check

1 Connector
2 Staple Shift
Motor, M4 (12-
5)
3 Finisher Driver
Board (13-1)
Be sure J8 is properly connected to the finisher
driver board.
Unplug J8 from the finisher driver board. Measure
the resistance between J8-11 and J8-12 on the
motor side. If it does not read 10 Ohms, replace the
stapler motor assembly (PN 11D0344).
If there is still a problem, replace the finisher driver
board (PN 11D0294).
Be sure J8 is properly connected to the finisher
driver board.
Unplug J8 from the finisher driver board. Measure
the resistance between J8-5 and J8-1/-2/-3/-4 on
the motor side. If it does not read 16.5 Ohms,
replace the staple shift motor (PN 11D0269).
If there is still a problem, replace the finisher driver
board (PN 11D0294).
Diagnostic Information 2-16