Tuning In A Video Channel On Your Tv; Using Your Dvd+Vcr For The Very First Time - Toshiba SD-34VLSL Owner's Manual

Tuning in a video channel on
your TV
Notes:
The output frequency of this video recorder
•
(VCR) is set at UHF channel 60. If channel 60
is already used by another TV station, or if the
picture is distorted, you can change the
transmitter channel of your DVD+VCR. Stages
5 ~ 8 will show you how to change the output
frequency of your DVD+VCR.
Your TV receives signals from the video
•
recorder (VCR) like another TV station. You
have to select a channel number on your TV
and tune it in so that you may watch video
tapes. If you have used a SCART then your
TV should already have a dedicated video
channel built into it, usually called AV.
1. Make sure that you have correctly installed your
DVD+VCR as described earlier in this book.
Press I/ to turn on your DVD+VCR.
Turn on your TV.
2. Insert a pre-recorded video tape into your
DVD+VCR and press PLAY w on the remote con-
trol.
Select a TV channel number on which you wish to
watch video's.
Don't worry if you don't have a video-tape to play
at this stage! If you switch your DVD+VCR on and
continue stages 3 ~ 4, instead of seeing video
playback tune your TV until you see a bright blue
screen.
3. Tune this channel until the video picture is sharp
and the sound is clear.
If you have used a SCART or AUDIO and VIDEO
cables you will not have to tune your TV, simply
select the AV channel. The AV channel is already
pre-tuned for optimum video playback on your TV.
4. Store this channel on your TV.
You will need to look at the TV instruction book if
you do not know how to do this.
5. Only carry out stages 5 ~ 8 if you cannot
obtain clear video playback as described in
stages 1 ~ 4. Select a TV channel number on
which you wish to watch video's.
Make sure that your DVD+VCR is in standby
pressing I/ on the remote control (only the clock
will be displayed).
6. Press REW b or FWD f on the front of
your DVD+VCR for more than 4 seconds.
RF60 will appear in the display window.
The following picture will be displayed on the TV
screen.
7. Use b or FWD f to select another video
channel. You may select any channel number
between 22 and 68.
You can also set it to "OFF" if there is any
interference when your TV is connected to the
VCR with a SCART lead.
8. Select a TV channel number on which you wish to
watch video's.
Press ON/STANDBY I/
DVD+VCR when you have finished.
Tune this channel so that a bright blue screen
appears. Store this channel on your TV.
Notes:
Make sure that you have correctly installed your
DVD+VCR and successfully tuned in a dedicat-
ed video channel on your TV. If you do not tune
in a dedicated video channel on your TV you
will be unable to view and record video tapes!
Using your DVD+VCR for the
very first time
The following picture will be displayed on the TV
screen when you have just connected your DVD+VCR
for the very first time.
A
N
Pr-12
ACMS
To activate tuning of TV stations, please follow stages
3 to 4 of "Tuning in TV Stations Automatically" in page
17.
1-20
RF CHANNEL 60
P SET i
R
on the front of your
B CH D DK E F I
NL P S SF ANDERE
OK i