Table of Contents
Advertisement
Connecting to a TV (Using the component video jacks)
TV or monitor with component video
(PROGRESSIVE) inputs
or
TV or monitor with component video
(INTERLACED) inputs
To Y video input
To P
input
To P
B
input
To audio input
PROGRESSIVE (525P (480P)) outputs/inputs
Some TVs or monitors are equipped with component
video inputs that are capable of reproducing a
progressively scanned video signal. Connecting to
these inputs allows you to view the high quality pictures
with less flicker.
Notes
• To output video signals in the progressive format, set
"PAL/Auto" to "Auto"
.
60
• A disc recorded in the PAL system cannot be viewed in
the progressive output format. Video signals of those discs
are output always in the interlaced output format.
INTERLACED outputs/inputs
Some TVs or monitors are equipped with component
video inputs. Connecting to these inputs allows you to
enjoy higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y,
C
, C
)
B
R
In some TVs or monitors, the color levels of the
playback picture may be reduced slightly or the tint may
change. In such a case, adjust the TV or monitor for
optimum performance.
SELECT
I
P
SELECT
I
P
video
VIDEO OUT
R
VIDEO
SELECT
video
I
P
S
To Y
To P
R
VIDEO
VIDEO
OUT
OUT
Audio cable
Switching the output signal (interlaced/
progressive) using the remote control
(only when the SELECT (I/P) switch is set to "P")
You can temporarily switch the output signal for better
picture quality.
Press PROGRESSIVE on the remote control.
Set to "P".
Set to "I".
* After setting this switch (I/P), be sure to
power off the DVD player then turn it on
to activate the setting.
AUDIO OUT
ANALOG
C
Ls
L
Y
5.1CH
SURROUND
BITSTREAM
/PCM
P
B
SUB
Rs
R
P
R
R
COAXIAL OPTICAL
L
2CH
DIGITAL
To 2CH AUDIO OUT
(R: red, L: white)
To P
B
VIDEO
OUT
• Make the following setting.
See "Customizing the Function Settings"
Setting
beginning from 56 .
TV
"Video Out Select" 60
TV or monitor
with component
video inputs
Notes
• Refer to the owner's manual of the connected equipment as
well.
• When you connect the DVD player to other equipment, be
sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• If you place the DVD player near a tuner or radio, the radio
broadcast sound might be distorted. In this case, place the
DVD player away from the tuner and radio.
• The output sound of the DVD player has a wide dynamic
range. Be sure to adjust the receiver's volume to a moderate
listening level. Otherwise, the speakers may be damaged by
a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the
DVD player's power cord. If you leave the amplifier power on,
the speakers may be damaged.
Signal flow
AV
Power cord
To wall outlet
"Analog Output" 61
"Video"
or
"Stereo"
"S Video"
AC IN
19
Advertisement
Table of Contents
