Troubleshooting - Toshiba SD-34VLSL Owner's Manual

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power.
The power is on, but
the DVD+VCR does not
work.
No picture.
Abnormal picture
and/or colour (pinkish,
greenish, etc.).
No sound.
The playback picture is
poor.
Cause
The power cord is disconnected.
DVD or VCR button is not switched
properly.
No disc is inserted.
No tape is inserted.
The TV is not set to receive DVD+VCR
signal output.
The video cable is not connected
securely.
The Progressive Scan is set to On on
the setup menu but is connected to a
standard(analog) television with compo-
nent video input.
Mismatch setting between TV and this
unit
Wrong connection.
The equipment connected with the
audio cable is not set to receive
DVD+VCR signal output.
The audio cables are not connected
securely.
The power of the equipment connected
with the audio cable is turned off.
The Digital Audio Output is set to the
wrong position.
The disc is dirty.
The TV channels are not tuned in properly
Tape heads are dirty.
Tape is a rental or was recorded on
another VCR.
This unit can only output 625p
Progressive scan picture.
1-50
Correction
Plug the power cord into the wall out-
let securely.
Refer to page 6.
Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
Select the appropriate video input
mode on the TV so the picture from
the DVD+VCR player appears on the
TV screen.
Connect the video cable into the jacks
securely.
Set Progressive Scan to Off
(see page 22).
Select the correct TV output select in
SETUP menu.
Check the connection.
Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD+VCR.
Connect the audio cable into the jacks
securely.
Turn on the equipment connected with
the audio cable.
Set the Digital Audio Output to the
correct position, then turn on the
DVD+VCR again by pressing + / 1.
Clean the disc.
Check tuning, carry out tuning again.
Clean video heads.
Use PR/TRK (+/-) for manual tracking
adjustment while tape is playing.
Make sure that your TV can support
625p Progressive scan picture or set
Progressive scan to off.