Operator Panel Cable/Cover Open Switch Assembly - Lexmark OPTRA 4069-XXX User Manual

4069-XXX

Operator Panel Cable/Cover Open Switch Assembly

Note: Pay careful attention to the cable routing through the printer
before you remove the operator panel cable/cover open switch
assembly.
1. Remove the left door, left cover, upper front cover, outer EMC
shield and inner EMC shield.
2. Disconnect the operator panel/cover open switch cable from the
engine board.
3. Remove the operator panel. Pull the cables through the
rectangular hole in the hinge pivot arm.
4. Plug the new operator panel cable into the operator panel and
snap the new cover open switch cable into the bracket
assembly.
5. Route the cables and torroid through the rectangular window in
the cover hinge pivot arm.
6. Snap the operator panel into the upper front cover.
7. Be sure the torroid is on the opposite end of the cables near the
engine board connectors.
8. Route the cables through the printer and down the inside of the
engine board shield.
9. Plug the cables into the engine board connectors.
Repair Information
4-49