Lexmark OPTRA 4069-XXX User Manual page 51

4069-XXX
The messages in the following table can occur in two ways. The
specified device could have been removed from the printer, for
instance to clear a paper jam. Otherwise, the device can still be
attached to the printer, but is experiencing a communications
problem, not fully connected, or having a hardware failure.
•
If the device is temporarily removed or not connected properly,
then reattach it. When the option is recognized, the printer
automatically clears the error and continues.
•
If the option is experiencing a hardware problem, turn the printer
off and back on. If the error occurs again, turn the printer off,
remove the option and call for service.
User Status Message
Turn Printer OFF to
Enable Option
Insert Duplex Front
Cover
Close Duplex Rear Door
Explanation
This message displays when a printer option,
Input Tray, Output Bin or Envelope Feeder, has
been attached while the printer is powered On. In
order to use the option, the printer must first be
powered off and back on again. Data loss results
if print jobs are active when the printer is power
cycled. If a print job is active, then remove the
option and finish the job. The printer automatically
clears the message once the option is removed.
Once the job is complete, turn off the printer and
attach the option again.
This message displays when the duplex front
access cover is not installed.
This message displays when the duplex rear door
is open.
Diagnostic Information
2-23