Lexmark J110 User Manual page 69

7
Once the Long Clean finishes, a test page prints four color bars with a corresponding number
below each color.
A
Clean [1]?=Go/Stop
8
For each color bar, press the
quality is not improved.
If you pressed
Printheads
test page with all four colors.
9
Because a Long Clean uses so much ink, we recommend not doing more than two. When the
Clean [1]?=Go/Stop
button for each color bar.
10
Press to go back to
Return
If the print quality is still unsatisfactory, try wiping the affected printhead to remove dried ink.
1
Press until the Utilities Menu appears.
Menu>
2
Press
Select.
3
Press until Change Printhead appears.
Menu>
4
Press .
Select
5
Open the printer front cover.
The carrier moves to the load position at the center of the printer.
6
Lift the carrier handle to unlatch the printhead from the carrier.
7
Grip the printhead and pull it up and out.
8
Use a clean, lint-free, damp cloth to gently wipe across the copper contact area.
9
To dissolve dried ink, hold the damp cloth against the printhead nozzles for about three
seconds. Gently blot and wipe dry.
10
Allow the copper contact time to dry.
message appears on the operator panel display for each color bar.
button if the quality is satisfactory or the
Stop
for any of the color bars, the printer does another Long Clean. A
Go
message appears on the display. After a few seconds the printer prints another
message appears on the operator panel display, press the
.
Ready
Copper contact
area
Nozzles
60
utton if the
Go b
Cleaning
Stop