1.
007-6388-001
Chapter 1
Introduction
Important: SGI Rackable server systems may sometimes require driver versions that are not
included in the original operating system release. When required, SGI provides these drivers on
an SGI Driver CD, which may ship with the system, or on the system disk (pre-installed in the
factory). For more information on this topic check with your sales or service representative.
The Rackable C1104-GP2/C1110-GP2 server is a 1U rackmount system (see
.
for an example)
In addition to the serverboard and chassis, various hardware components may be included with
the system, as listed:
•
Eight 4-cm chassis fans
•
One internal air shroud
•
Two passive 1U CPU heatsinks
•
Riser cards as follows:
–
One riser for two internal PCIe 3.0 x16 cards, (full-height cards)
–
One riser that supports a low-profile PCIe 3.0 x8 card (external-facing rear card) and
one internal PCIe 3.0 x8 low-profile card
•
Power cables for PCI cards
•
SATA/SAS drive accessories:
–
One SATA/SAS backplane
–
Four 3.5-inch hot-swap disk drive carriers (RAID must be enabled for hot swap)
or
–
Ten 2.5-inch hot-swap disk drive carriers (RAID must be enabled for hot swap)
•
Optional CD/DVD drive (with C1104-GP2 model only)
•
Two power supplies
•
One rackmount kit
Figure 1-1 on page 2
1