No Jobs To Cancel; Not Ready - Lexmark E460dw User Manual

No jobs to cancel

Wait for the message to clear.

Not Ready

The printer is not ready to receive or process data, or the printer ports are offline.
Parallel/Parallel <x>
The printer is connected to a parallel port. Parallel interface is the active communication link. Parallel indicates
that the printer is using the parallel port. Parallel <x> indicates the active interface is connected to the printer
through PCI connector x.
Note: The current interface displays on the menus settings page.
Wait for the message to clear.
PC Kit Life Warning
This is the final warning message for the photoconductor kit. The photoconductor kit is near exhaustion. The printer
continues printing unless the value for the Cartridge Alarm is changed from the printer control panel or set to On
from the Supply Notifications Web page (located on the Embedded Web Server).
If the setting is On, then the printer stops printing. Press to select Continue. The printer continues to print until
the photoconductor kit is completely exhausted. When the photoconductor kit is exhausted, replace it.
[PJL RDYMSG]
This is the Printer Job Language (PJL) Ready message. It appears after the Ready or Power Saver message. If the
message string is too long, it is truncated.
Wait for the message to clear.
Power Saver
The printer is saving power while it waits for the next print job. Send a job to print to take the printer out of Power
Saver mode.
Printing
Wait for the message to clear.
Programming flash DO NOT POWER OFF
Wait for the message to clear.
Warning—Potential Damage: Do not turn the printer power off while Programming flash appears on the
display.
Understanding printer messages
124